top of page

Why Is My Toilet Running? How to Find and Fix the Cause

Writer: Asher
Asher
37 minutes ago
3 min read

A toilet that keeps running is almost always caused by a worn flapper, a faulty fill valve, a chain that is too tight or too loose, or a float set too high. Most of these can be found in about 10 minutes, and a running toilet can waste hundreds of gallons of water a day, so it is worth fixing quickly.

The 5-minute version 1. Lift the tank lid. Water should stop about an inch below the overflow tube. 2. Do the dye test. Put food coloring in the tank and wait 10 minutes without flushing. Color in the bowl means a leaking flapper. 3. Check the chain. It should have a little slack and not be caught under the flapper. 4. Check the fill valve. If water keeps running into the overflow tube, the float or fill valve needs adjusting or replacing. 5. Still running? Call a plumber before the water bill finds you.

What is happening inside the tank

When you flush, the flapper lifts and the tank empties into the bowl. The fill valve then refills the tank, and a float shuts it off at the right level. A running toilet means one of those parts is not sealing or not shutting off, so water keeps moving.

The 4 most common causes

1. A worn or warped flapper

This is the most common cause. Rubber flappers harden and warp over the years, and in Los Angeles hard water speeds that up. If the flapper does not seal, water leaks from the tank into the bowl and the fill valve keeps topping it off. You may hear the toilet "phantom flush" every so often.

2. A bad fill valve

If water is still running into the tank after it is full, and you can see it spilling into the overflow tube, the fill valve is not shutting off. Sometimes the float just needs adjusting. If the valve is old or cracked, it needs to be replaced.

3. A chain that is too tight or too loose

A chain with no slack holds the flapper slightly open. A chain that is too long can slip under the flapper and keep it from closing. You want about half an inch of slack.

4. A water level that is set too high

If the water level is above the top of the overflow tube, water drains down it constantly. Lower the float or turn the adjustment screw on the fill valve until the water sits about an inch below the top of the tube.

How to do the dye test

  1. Take the lid off the tank and put 10 drops of food coloring in the tank water.

  2. Do not flush for 10 to 15 minutes.

  3. If color shows up in the bowl, the flapper is leaking and needs to be replaced.

What to try yourself

  • Wipe the flapper and the seat it rests on with a cloth. Mineral buildup can keep it from sealing.

  • Adjust the chain so there is a little slack.

  • Replace the flapper with one that matches your toilet model. Turn off the supply valve first and flush to empty the tank.

When to call a plumber

Call if you replaced the flapper and it still runs, if the fill valve is leaking at its base, if water is pooling around the toilet, or if the toilet is older and the parts are corroded. A running toilet can also hide a leak at the supply line or the wax ring, and it adds to your water bill every day. Our toilet repair service fixes running toilets, and if yours is old enough that repairs keep failing, toilet installation may make more sense. If your water bill is high and you cannot find the source, read about finding a hidden water leak.

Questions we hear

How much water does a running toilet waste?

The EPA says a leaking toilet can waste about 200 gallons a day or more, and a silent leak can go unnoticed for months. Use the dye test to find out.

Can a running toilet damage anything?

Not by itself, but the extra water adds to your bill, and a leak around the base can damage the floor over time.

Why does my toilet run for a few seconds and then stop?

That is usually a slow flapper leak. The tank level drops, the fill valve runs to top it off, and the cycle repeats. Replacing the flapper normally fixes it.

Toilet still running? Call or text Boss Plumbing at (323) 464-4700. We are open 24 hours, and we are the quickest plumber to reach you in Los Angeles. You can also contact us here.

 
 
 

Comments


© 2026 Boss Plumbing. All rights reserved. License #579704

Boss Plumbing & Heating logo

Family owned and operated for over 37 years. Your trusted Los Angeles plumbing experts for residential and commercial services.

  • Boss Plumbing on Instagram
  • Boss Plumbing on X
  • Boss Plumbing on Pinterest
  • Boss Plumbing on YouTube

Contact Us

826 Seward St, Los Angeles, CA 90038

bottom of page